Need settings help...

[redtrucknc]

I'm not seeing all channels with a Pansat 2700A, and was wondering if there are settings I need to change to get the missing ones..

[whatsup745]

Settings are very important for getting everything you possibly can.
The settings we enter into our receivers tell the receiver what type of LNBs and switches we are using outside on our dishes.

So for us to tell you what settings you should have we need to know what types of LNB's you have on your dish..what type of switch you are using...and how the LNB's are wired to the switch and what port numbers are wired to which.

Provide this info, and provide your settings and we can tell you which are wrong !

[redtrucknc]

All 3 are DTV 18" and LNBs

The switch is a DISq (I believe) 4 input, 3 are being used, about the size of an older dtv switch

Settings in 2700a are as follows.
LNB type standard on all 3
LNB freq 11250 on all 3
22 KHz OFF all 3
DISeqC 1=8.10 2=7 3= nim
Legacy NONE all 3
Skew -45 -45 45
TP 12370 12225 12239
Positioner DISABLED all 3
Sat Scan ALL

[seansterx]

All 3 are DTV 18" and LNBs

The switch is a DISq (I believe) 4 input, 3 are being used, about the size of an older dtv switch

Settings in 2700a are as follows.
LNB type standard on all 3
LNB freq 11250 on all 3
22 KHz OFF all 3
DISeqC 1=Echo 7 2= Echo 10/113= nim
Legacy NONE all 3
Skew -45 -45 45
TP 12224(110), 12239(119), 12224(91)
Positioner DISABLED all 3
Sat Scan ALL

Change the one in RED...Make sure you change cable on the diseqc 4x1 too.. and Scan sat again