IPHONE
01-05-2009, 11:19 AM
C &P from NYGTHRYDER
I put this together for those with Dish500+ using the coolsat 6100, 7000 and 7100 to get all International channels.
Anywhere it asks for pin put it in and yes/no prompts assume yes unless otherwise told. Plus knowledge of your dish settings is a plus
First make sure you have the most current fix loaded.
Do factory reset- menu/installation/system recovery/system restore to factory default
Set language/time zone and NO for auto detect
Next go to anik3 118.8 as listed in sat menu
Lnb frequency will be set at 10750
you will be using ocs-dp as your lnb type and your appropriate disec setting
Now the second line “frequency" is where we’re going to do some changes
Normally from factory settings the first one listed is 11715 if not highlight and arrow left till it’s shown.
With 11715 highlighted arrow once to the right and a new frequency number appears.
Hit the red button on remote to delete and you will be prompted answer is yes to delete. Repeat this process till the only one left is the 11715v that we started at.
Next were going to add tp's by hitting the green button on remote (frequency must be highlighted)
11744v 20000
11958v 20000
11988v 20000
12049v 20000
12079v 20000
12109v 20000
12141v 20000
12445v 20000
12475v 20000
12501v 20000
12537v 20000
12567v 20000
12597v 20000
12811v 20000
12872v 20000
Once complete, with freq still highlighted hit the ok button and make sure you have all those tp's listed. if yes procede,if no then go add them before going to next step
go to channel search press ok then down to start search and press ok, when complete you should have all international channels if your dish is set correctly and signal strenght is good.
I put this together for those with Dish500+ using the coolsat 6100, 7000 and 7100 to get all International channels.
Anywhere it asks for pin put it in and yes/no prompts assume yes unless otherwise told. Plus knowledge of your dish settings is a plus
First make sure you have the most current fix loaded.
Do factory reset- menu/installation/system recovery/system restore to factory default
Set language/time zone and NO for auto detect
Next go to anik3 118.8 as listed in sat menu
Lnb frequency will be set at 10750
you will be using ocs-dp as your lnb type and your appropriate disec setting
Now the second line “frequency" is where we’re going to do some changes
Normally from factory settings the first one listed is 11715 if not highlight and arrow left till it’s shown.
With 11715 highlighted arrow once to the right and a new frequency number appears.
Hit the red button on remote to delete and you will be prompted answer is yes to delete. Repeat this process till the only one left is the 11715v that we started at.
Next were going to add tp's by hitting the green button on remote (frequency must be highlighted)
11744v 20000
11958v 20000
11988v 20000
12049v 20000
12079v 20000
12109v 20000
12141v 20000
12445v 20000
12475v 20000
12501v 20000
12537v 20000
12567v 20000
12597v 20000
12811v 20000
12872v 20000
Once complete, with freq still highlighted hit the ok button and make sure you have all those tp's listed. if yes procede,if no then go add them before going to next step
go to channel search press ok then down to start search and press ok, when complete you should have all international channels if your dish is set correctly and signal strenght is good.