silly87
02-11-2009, 10:04 PM
Cloning A CWS 800
as posted bt smitty26.
C&P..Not sure who created this post
How To Clone(Transfer Data)CW800S.
I have seen members asking about How To transfer Data from a programmed CW800S to a CW800S that is not programmed.I have accomplished this useing the following steps:
1-Make sure both receivers are turned off by the rear (Main Power Switch).Disconnect,antenna,and T.V. cables.
2-Connect a NULL Modem Cable to Both receivers.
3-Turn the programmed receiver on with the rear main power switch,let the programmed receiver boot all the way up,and press the On/Off switch on the front of the receiver,or the On/Off Buttton,on the remote control.You should this ----(Stanby Mode)in the LED.
4- Turn the Rear main switch On,on the receiver that you want to transfer the Data (to),and let it boot up until you see (Start Up) in the LED of this receiver.
5- Now you should see H blinking in the programmed receiver.Useing the remote,point the remote at the programmed receiver,and enter the numbers 444,you will see the Data begin to transfer in both Receiver's LEDS.
6-DO NOT INTERFERE,with the transfer,until both receivers are completely Finished.When the receiver (Receiveing the Data is finished,It will display a Channel Number,in the LED).
7-Turn off the Rear Main switch,on both receivers.Disconnect the NULL MODEM Cable.
8-Connect the dish cables,and T.V. cables,and watch T.V.
Also.......
I used the above info and did four family boxes. The only thing I had happen was at the finish my unit (the one I was Cloning from) said ERROR 011. I left everything as is and started the process over and all was well. This happened to all the boxes. So don't panic if you get the error, as far as I can make out it's normal.
end c/p
as posted bt smitty26.
C&P..Not sure who created this post
How To Clone(Transfer Data)CW800S.
I have seen members asking about How To transfer Data from a programmed CW800S to a CW800S that is not programmed.I have accomplished this useing the following steps:
1-Make sure both receivers are turned off by the rear (Main Power Switch).Disconnect,antenna,and T.V. cables.
2-Connect a NULL Modem Cable to Both receivers.
3-Turn the programmed receiver on with the rear main power switch,let the programmed receiver boot all the way up,and press the On/Off switch on the front of the receiver,or the On/Off Buttton,on the remote control.You should this ----(Stanby Mode)in the LED.
4- Turn the Rear main switch On,on the receiver that you want to transfer the Data (to),and let it boot up until you see (Start Up) in the LED of this receiver.
5- Now you should see H blinking in the programmed receiver.Useing the remote,point the remote at the programmed receiver,and enter the numbers 444,you will see the Data begin to transfer in both Receiver's LEDS.
6-DO NOT INTERFERE,with the transfer,until both receivers are completely Finished.When the receiver (Receiveing the Data is finished,It will display a Channel Number,in the LED).
7-Turn off the Rear Main switch,on both receivers.Disconnect the NULL MODEM Cable.
8-Connect the dish cables,and T.V. cables,and watch T.V.
Also.......
I used the above info and did four family boxes. The only thing I had happen was at the finish my unit (the one I was Cloning from) said ERROR 011. I left everything as is and started the process over and all was well. This happened to all the boxes. So don't panic if you get the error, as far as I can make out it's normal.
end c/p